- Bugfixes
- Bugfixes
Added:
- New mounting system calculation for stock screws on concrete roofs (available in Italy)
Added:
- Option to create a quick quotation document with your own invoice items (roll-out planned)
Added:
- When using multiple buildings, it is now more clear which buildings have already been calculated and which have not
- Wind load zones for Guadeloupe and Martinique updated
- Wind load zones for Sweden updated
Changed:
- The stone output in the PDF is now automatically activated when stones are used
Fixed:
- Zooming with the mouse wheel in the module assignment possible again
- When using multiple buildings, not all warnings were displayed in the PDF in some cases
- Export of electrical data sheets possible again
- Fixed inaccuracy in the track sawing plan
- Rail saw plan was too often in the table of contents (PDF)
Added:
the cutting waste in the cutting plan is now taken into account.
Use of contact latch for insertion systems.
Fixed:
Number of grounding connectors in the parts list corrected.
Added:
- New coverings: Solar-Planit now supports the two new sheet metal seam types snap and angle seam. The default for the seam calculation has also been changed.
- Longer modules for Flat Roof II South: With version 13.3.0, modules with a length of up to 2.28m can be used for the novotegra mounting system Flat Roof II South.
Fixed:
- Cover caps for green roofs are planned correctly again.
- The rafter display in the PDF documentation has been corrected.
Added:
Fitting Supplementary Items for your interconnection are offered now and can be added to the bill of materials and therefore also transfered to the webshop.
- Enphase systems can be planned within Solar-Planit. All necessary components will be selected in the pod Supplementary Items.
- User modules can be created with bifacial coefficient and will be considered in the simulation.
- All electrical data sheets are downloadable at once (you get all data sheets by clicking on button) in the documentation pod.
Added:
- Solar-Planit now supports multiple buildings/roofs within one project.
- The full electrical simulation and inverter design is available for each building/roof separately.
- A combined bill of materials is created, covering each roof.
- The documentation features each roof in a separate section of the PDF.